Brief:
The Aerotech H210 Redline RMS reload is a great motor to use for one of those rockets after you certify level 1. It has nice long bright red flame and just pushes the rocket off the pad like a bullet out the gun. You got to keep your eye on your rocket when using this motor because it gets your rocket moving really fast.

Construction:
RMS hardware parts:

• 29mm aft closure
• 29/240 case
• 29mm standard or plugged forward closure
• 29mm forward seal ring

Reload kit parts:

• 1 nozzle
• 1 liner
• 4 propellant grains
• 1 aft O-ring
• 1 forward O-ring
• 1 forward seal ring O-ring
• 1 aft insulator
• 1 ejection charge cap
• 1 FirstFire igniter
• 1 ejection charge container
• 1 nozzle Cap
• 1 RMS-Plus delay element
• 1 delay insulator
• 1 delay O-ring
• 1 aft delay spacer
• 1 forward delay spacer

Items needed for use:

• Synco Super Lube or other grease
• hobby knife or scissors
• wet wipes or damp paper towels

This motor goes together in a straightforward manner. You start out by greasing all the parts that need to be greased. [WARNING: Do not get grease on either sides of the delay element!] The only problems I ran into while building the motor was trying to figure which ring is which. Other than that, the building of the motor went smoothly.

Flight:
This motor is great to fly with. The only down side to this motor when flying with it is that its burn time is only about 1 second otherwise this is a great motor to fly with.

Recovery:
Ejection was right on time.

Summary:
This motor rocks!

Overall Rating: 5 out of 5